Ordinary tent construction method

The usage of various tents is different, let's first talk about the method of setting up a regular tent.

Firstly, choose the campsite and lay the inner tent flat on the ground (usually the inner tent, but there are also some who first support the outer tent and hang the inner tent inside, such as Eurohike, which principle is to wear the layer of the tent pole). Take out the folded tent pole, straighten it section by section, and connect it into a long pole. According to the instructions, thread it into the tent pole cover above the tent, commonly known as the cross crossing method.

After both poles are threaded in. Insert one end of each pole into the small hole on the corner of the tent, and then two people hold the two active heads at the same time. Push the pole inward and arch the tent until the head on this side can also be inserted into the small hole. After inserting it, the shape of the tent becomes. Tie the intersection of the tent poles with a rope, select the direction of the door, and then fix the tent on the ground. Use ground nails to hook the four corners of the ring and insert it into the soil, so that the bottom of the tent extends and the entire tent is taut. Hang the outer tent again, open the outer tent, cover it with the inner tent, and the tent will be set up.

Matters needing attention

Pay attention that the doors of the internal and external curtains should face in one direction, with the four corners hanging on the four corners of the internal tent (near the position of the insertion pole, you can find the hanging place). Some also nail the four corners of the external tent with ground nails near the four corners of the internal tent to see if there are any hanging rings that can be nailed to the ground. Make sure that the external tent is also tight and in areas where the internal tent is not attached, so that if you fish, the internal tent will not get wet and due to breathing, In the morning, there will be a layer of dew or frost on the outer tent, which will not wet the inner tent if not adhered to. However, there are also bad tent frosts that can accumulate on the inner tent. If you wake up early, it will snow inside the tent.

There are also some ropes on the outer tent that are used to reinforce the tent. It is generally not necessary to pull them when there is no strong wind. It is best to pull them if you are not worried, and also use ground nails. Several ropes should be pulled evenly with force. In the morning, if the weather is good, it's best not to immediately put in the tent and let it dry a little. If you get caught in the rain, remember to spread it out and let it dry when you go home, otherwise it will become moldy. To collect the tent, first remove the outer tent. After removing the nails on the inner tent, don't rush to remove the tent poles. Open the door, lift the tent and shake it, pour out the soil inside, and then place it on the ground. Take off both tent poles by one end, and this will flatten the tent. Push the tent poles out from one end, don't pull them, they are inserted and will scatter when pulled. Finally, fold up the tent pole, put the inner and outer curtains back in the bag, and don't lose the floor nails.